Wasp-bar-code W-300 Manual de usuario descargar pdf (Pagina 20)

Chapter 2

Resetting the Printer

Resetting the Printer to Factory

Default Settings

1. Turn on the printer and wait for approximately 5 seconds.

2. Press the “Feed” button for 10 seconds. The “Ready” indicator and

“Power” indicator will go off in order.

3. When the two indicators become lit again, release the feed button.

4. At this moment, the printer will feed 12 inches of label stock, and will reset

itself to the factory default settings.

Note: All settings are stored in non-volatile EPROM and cannot be erased when

the printer is turned off.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sin comentarios

Wasp-bar-code W-300 Manual de usuario Pagina 20