Wasp-bar-code Wasp WPL606 Manual de usuario descargar pdf (Pagina 16)

3.6 Self-test

To initiate the self-test mode, press the MENU button to advance the selection to

Printer Test. Press the EXE button to enter the submenu and press the MENU

button to advance the selection to Printer Config. Press EXE button to print the

printer’s internal settings. During self-test, a check pattern is used to check the

performance of the thermal print head. Following the check pattern, the printer

prints internal settings as listed below:

Print head check pattern

Firmware version

Firmware checksum

Printed mileage (meter)

Serial port configuration

Country code

Print speed (inch/sec)

Print darkness

Label size (inch)

Gap distance (inch)

Gap/black mark sensor sensitivity

Numbers of download files

Total & available memory space

Figure 17: Printout of self-test

3.7 Dump Mode

To enter dump mode, press the MENU button to select the Printer Test menu.

Press EXE then SELECT until Dump Mode Off is displayed. Press INC to change

the display to Dump Mode On. In this mode, any character sent from the host

computer will be printed in two columns as shown in Figure 18.

On the left side of the paper are the characters received, and on the right side are

the corresponding hexadecimal values. This is used for verification of

programming commands or debugging of printer programs. Reset the printer by

pressing the FEED button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Wasp-bar-code Wasp WPL606 Manual de usuario Pagina 16