Wasp-bar-code WLP 4170 CCD Manual de usuario descargar pdf (Pagina 13)

*Default

00 Default* 04 Continuous

Setup & Configuration

—Scanning Modes

Begin

Set Scanning Mode

Exit

The 'Scanning Mode' option controls the trigger and LED settings for the WLP

4170 CCD Scanner.

NOTE: For help in configuring these settings, consult the programming

steps on page 5.

Continuous Mode

* Trigger with 10 Sec. Delay

When this option is selected, the LEDs are

visible at all times. Under this option, you cannot

read the same bar code back-to-back.

This is the default option for the

Wasp WLP 4170 CCD Scanner.

When this option is selected, the

scanner will stop scanning when

there is a successful read or no

code is scanned after 10 seconds.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sin comentarios

Wasp-bar-code WLP 4170 CCD Manual de usuario Pagina 13